Previously repmgr would abort with an unhelpful message about being
unable to parse CSV output.
With this commit, it will continue running, and display a list of
inaccessible nodes as an addendum to the main output (unless --csv
or --terse options are specified).
Addresses GitHub #246.
This is to facilitate remote invocation of repmgr when the repmgr
binary is located somewhere other than the PostgreSQL binary directory, as it
cannot be assumed all package maintainers will install repmgr there.
This parameter is optional; if not set (the default), repmgr will fall back
to "pg_bindir" (if set).
Addresses GitHub #246.
In some circumstances, e.g. while performing a switchover, it is essential
that repmgrd does not take any kind of failover action, as this will put
the cluster into an incorrect state.
Previously it was necessary to stop repmgrd on all nodes (or at least
those nodes which repmgrd would consider as promotion candidates), however
this is a cumbersome and potentially risk-prone operation, particularly if the
replication cluster contains more than a couple of servers.
To prevent this issue from occurring, this patch introduces the ability
to "pause" repmgrd on all nodes wth a single command ("repmgr daemon pause")
which notifies repmgrd not to take any failover action until the node
is "unpaused" ("repmgr daemon unpause").
"repmgr daemon status" provides an overview of each node and whether repmgrd
is running, and if so whether it is paused.
"repmgr standby switchover" has been modified to automatically pause repmgrd
while carrying out the switchover.
See documentation for further details.
Previously, "repmgr standby switchover" used the configuration file parameters
"reconnect_interval" and "reconnect_attempts" to define a timeout to determine
whether the current primary (demotion candidate) has shut down.
However, these parameters are intended for primary failure detection and are
generally lower in value, while a controlled shutdown may take longer, resulting
in the switchover being aborted as repmgr was not waiting long enough.
To prevent this happening, parameter "shutdown_check_timeout" has been added.
This complements the existing "standby_reconnect_timeout" parameter used
by "repmgr standby switchover".
Implements GitHub #504.
