The string may not always start with "PostgreSQL" when building
against non-community versions.
Life would be much easier here if there was an option like
"pg_config --version-number" or similar.
If executing "repmgr standby clone --replication-conf-only" on a node
which was set up without replication slots, but the repmgr configuration
was since changed to "use_replication_slots=1", repmgr will attempt to
create the replication slot. This will however fail if "slot_name"
is not set in the node's record, so have repmgr set the slot_name in
this case.
It might be preferable to preemptively create the slot name for each
node when configuring the cluster, however this would be a behavioural
change which would be better off in a major release (for example, it's
conceivable a user runs sanity checks on the node records and expects
to find the slot names empty if replication slots are not in use).
Some of the more generically named functions are at risk of colliding
with functions defined in other libraries. To mitigate that risk,
prefix with "repmgr_", unless the name already has some reference
to repmgr.
This requires an extension version bump.
RM20471.
As it's possible to specify the connection information for any available
node, but currently not possible to rejoin to a node other than the
primary, explicitly mention what the rejoin target will be.
In a corner-case situation where a standby is unable to attach to
the new primary due to a mismatch in the WAL stream, the connection
used to verify the recovery status of the new primary was not being
closed, leading to a risk of connection exhaustion on the new primary.
Addresses GitHub #682.
Previously, repmgr would forcibly change the permissions on a data
directory to 0700. However from PostgreSQL 11, 0750 is also valid,
so that value should not be changed.
When cloning a standby, it's possible to do a "raw" clone by providing
-D/--data-directory but no repmgr.conf file. However the code which
creates "standby.signal" was assuming the presence of a valid
repmgr.conf complete with "data_directory" configuration.
This is very much a niche-use case.
Here the compiler may complain that the source length is being used,
though in all cases the source length was previously used to
define the length of the destination buffer, so it's not actually
a problem.
If neither the local node nor the upstream are available, and
"standby_disconnect_on_failover" is set, attempting to fetch
the walreceiver PID will result in repmgrd terminating.
Add a check that the connection is valid before attempting to
fetch the walreceiver PID.
Addresses GitHub #675.
This overrides the equivalent setting in repmgr.conf, if present.
Note this option was available in repmgr versions prior to 4.0, but
was assumed to be redundant. However recently a use-case was made
for its reintroduction.
