Currently the (very generic sounding) "standby_reconnect_timeout" configuration
file parameter is used in several different contexts and it would be useful
to have more granular control over the different timeouts it's used to configure.
This patch introduces "node_rejoin_timeout", used in place of "standby_reconnect_timeout"
(which wasn't documented) when "repmgr node rejoin" is executed, to determine
how long to wait for the node to rejoin the replication cluster.
Additionally "repmgrd_standby_startup_timeout" is introduced as a timeout for
failover situations, when repmgrd executes "repmgr standby follow" to follow
a new primary, and waits for the standby to restart and become available
for connections.
"standby_reconnect_timeout" is now only relevant for "repmgr standby switchover".
Implements GitHub #454.
pg_rewind is not part of the core distribution for those, but we
provided support in repmgr 3.3 so should extend it to repmgr 4.
Note that there is no check in place whether the pg_rewind binary
exists, so it's up to the user to ensure it's present.
Addresses GitHub #413.
During a switchover operation, once the demoted primary has been restarted
as a standby, repmgr attempts to reconnect to verify its status and drop
any redundant replication slots. However it's possible the standby may still
be in the startup phase, so poll for "standby_reconnect_timeout" seconds
before giving up.
Addresses GitHub #408.
Previously, if an issue was encountered with the old primary, but user
provided -F/--force to have repmgr promote the standby anyway, repmgr
would exit with the log message "STANDBY SWITCHOVER is complete"
and exit code 0 (SUCCESS).
To better report this partial completion, repmgr will now emit the message
"STANDBY SWITCHOVER has completed with issues" (and a HINT to check preceding
log messages) and new exit code 22 (ERR_SWITCHOVER_INCOMPLETE).
