Explicitly check whether the "repmgr node rejoin" command on the
demotion candidate succeeded. Due to the way SSH execution is
currently implemented, we can return either the command execution
status or the command output; to ensure any errors are available,
log them to a temporary file on the demotion candidate and note
its location in case of an error.
While we're at it, improve error message handling when the demotion
candidate fails to rejoin.
Unfortunately it hasn't been possible yet to include all available
configuration items in the main documentation, but we should at least
make it easier to find the full list.
If a PostgreSQL instance was shut down while repmgrd was running, and
repmgrd was subsequently restarted (this chain of events could occur
during e.g. a server reboot), the node record will have been set to
"inactive". Previously, in this case repmgrd would refuse to start up.
However, as we can determine the node is running, it should normally
be no problem to automatically set the node record to "active".
The old behaviour can be restored by setting the new parameter
"repmgrd_exit_on_inactive_node" to "true".
RM19604.
As it's possible to specify the connection information for any available
node, but currently not possible to rejoin to a node other than the
primary, explicitly mention what the rejoin target will be.
Previously, repmgr would forcibly change the permissions on a data
directory to 0700. However from PostgreSQL 11, 0750 is also valid,
so that value should not be changed.
If neither the local node nor the upstream are available, and
"standby_disconnect_on_failover" is set, attempting to fetch
the walreceiver PID will result in repmgrd terminating.
Add a check that the connection is valid before attempting to
fetch the walreceiver PID.
Addresses GitHub #675.
This overrides the equivalent setting in repmgr.conf, if present.
Note this option was available in repmgr versions prior to 4.0, but
was assumed to be redundant. However recently a use-case was made
for its reintroduction.
