repmgr daemon unpauserepmgrdunpausingrepmgr daemon unpauserepmgr daemon unpauseInstruct all &repmgrd; instances in the replication cluster to resume failover operationsDescription
This command can be run on any active node in the replication cluster to instruct all
running &repmgrd; instances to "unpause"
(following a previous execution of )
and resume normal failover/monitoring operation.
It's important to wait a few seconds after restarting PostgreSQL on any node before running
repmgr daemon pause, as the &repmgrd; instance
on the restarted node will take a second or two before it has updated its status.
Executionrepmgr daemon unpause can be executed on any active node in the
replication cluster. A valid repmgr.conf file is required.
It will have no effect on nodes which are not already paused.
Example
$ repmgr -f /etc/repmgr.conf daemon unpause
NOTICE: node 1 (node1) unpaused
NOTICE: node 2 (node2) unpaused
NOTICE: node 3 (node3) unpausedOptions
Check if nodes are reachable but don't unpause &repmgrd;.
Exit codes
One of the following exit codes will be emitted by repmgr daemon unpause:
&repmgrd; could be unpaused on all nodes.
&repmgrd; could not be unpaused on one or mode nodes.
See also,