repmgr service unpause repmgrd unpausing repmgr service unpause repmgr service unpause Instruct all &repmgrd; instances in the replication cluster to resume failover operations This command can be run on any active node in the replication cluster to instruct all running &repmgrd; instances to "unpause" (following a previous execution of ) and resume normal failover/monitoring operation. It's important to wait a few seconds after restarting PostgreSQL on any node before running repmgr service pause, as the &repmgrd; instance on the restarted node will take a second or two before it has updated its status. PostgreSQL must be accessible on all nodes (using the conninfo string shown by repmgr cluster show) from the node where repmgr service pause is executed. repmgr service unpause can be executed on any active node in the replication cluster. A valid repmgr.conf file is required. It will have no effect on nodes which are not already paused. $ repmgr -f /etc/repmgr.conf service unpause NOTICE: node 1 (node1) unpaused NOTICE: node 2 (node2) unpaused NOTICE: node 3 (node3) unpaused --dry-run Check if nodes are reachable but don't unpause &repmgrd;. One of the following exit codes will be emitted by repmgr service unpause: SUCCESS (0) &repmgrd; could be unpaused on all nodes. ERR_REPMGRD_PAUSE (26) &repmgrd; could not be unpaused on one or mode nodes. , , , ,