repmgr daemon stop repmgrd stopping repmgr daemon stop repmgr daemon stop Stop the repmgrd daemon This command stops the repmgrd daemon on the local node. If &repmgr; was installed from packages, it is essential that repmgrd is configured to use the package-provided service start/stop commands. See below for details. repmgr daemon stop will execute the command defined by the repmgrd_service_stop_command parameter in repmgr.conf. This must be set to a shell command which will stop repmgrd; if &repmgr; was installed from a package, this will be the service command defined by the package. For more details see Appendix: &repmgr; package details. If repmgrd_service_stop_command is not set, &repmgr; will default to executing repmgrd directly. If &repmgr; was installed from a system package, and you do not configure repmgrd_service_stop_command to an appropriate service command, this may result in the system becoming confused about the state of the repmgrd service; this is particularly the case with systemd. --dry-run Check prerequisites but don't actually attempt to stop repmgrd. This action will output the command which would be executed. Following exit codes can be emitted by repmgr daemon stop: SUCCESS (0) repmgrd could be stopped. ERR_REPMGRD_SERVICE (27) repmgrd could not be stopped.