repmgr primary register repmgr primary register repmgr primary register initialise a repmgr installation and register the primary node repmgr primary register registers a primary node in a streaming replication cluster, and configures it for use with &repmgr;, including installing the &repmgr; extension. This command needs to be executed before any standby nodes are registered. It's possibly to install the &repmgr; extension manually before executing repmgr primary register; in this case &repmgr; will detect the presence of the extension and skip that step. Execute with the --dry-run option to check what would happen without actually registering the primary. If providing the configuration file location with -f/--config-file, avoid using a relative path, as &repmgr; stores the configuration file location in the repmgr metadata for use when &repmgr; is executed remotely (e.g. during ). &repmgr; will attempt to convert the a relative path into an absolute one, but this may not be the same as the path you would explicitly provide (e.g. ./repmgr.conf might be converted to /path/to/./repmgr.conf, whereas you'd normally write /path/to/repmgr.conf). repmgr master register can be used as an alias for repmgr primary register. --dry-run Check prerequisites but don't actually register the primary. -F, --force Overwrite an existing node record Following event notifications will be generated: cluster_created primary_register