repmgr daemon stop repmgrd stopping repmgr daemon stop repmgr daemon stop Stop the repmgrd daemon This command stops the repmgrd daemon on the local node. By default, &repmgr; will wait for up to 15 seconds to confirm that repmgrd stopped. This behaviour can be overridden by specifying a diffent value using the --wait option, or disabled altogether with the --no-wait option. If PostgreSQL is not running on the local node, under some circumstances &repmgr; may not be able to confirm if repmgrd has actually stopped. repmgr daemon stop will execute the command defined by the repmgrd_service_stop_command parameter in repmgr.conf. This must be set to a shell command which will stop repmgrd; if &repmgr; was installed from a package, this will be the service command defined by the package. For more details see Appendix: &repmgr; package details. If &repmgr; was installed from a system package, and you do not configure repmgrd_service_stop_command to an appropriate service command, this may result in the system becoming confused about the state of the repmgrd service; this is particularly the case with systemd. --dry-run Check prerequisites but don't actually attempt to stop repmgrd. This action will output the command which would be executed. -w --wait Wait for the specified number of seconds to confirm that repmgrd stopped successfully. Note that providing --wait=0 is the equivalent of --no-wait. --no-wait Don't wait to confirm that repmgrd stopped successfully. This is equivalent to providing --wait=0. Following exit codes can be emitted by repmgr daemon stop: SUCCESS (0) repmgrd could be stopped. ERR_BAD_CONFIG (1) repmgrd_service_stop_command is not defined in repmgr.conf. ERR_REPMGRD_SERVICE (27) repmgrd could not be stopped. ,