repmgr daemon start repmgrd starting repmgr daemon start repmgr daemon start Start the repmgrd daemon This command starts the repmgrd daemon on the local node. If &repmgr; was installed from packages, it is essential that repmgrd is configured to use the package-provided service start/stop commands. See below for details. repmgr daemon start will execute the command defined by the repmgrd_service_start_command parameter in repmgr.conf. This must be set to a shell command which will start repmgrd; if &repmgr; was installed from a package, this will be the service command defined by the package. For more details see Appendix: &repmgr; package details. If repmgrd_service_start_command is not set, &repmgr; will default to executing repmgrd directly. If &repmgr; was installed from a system package, and you do not configure repmgrd_service_start_command to an appropriate service command, this may result in the system becoming confused about the state of the repmgrd service; this is particularly the case with systemd. Following exit codes can be emitted by repmgr daemon start: SUCCESS (0) repmgrd could be started. ERR_REPMGRD_SERVICE (27) repmgrd could not be started.