repmgr daemon unpause repmgr daemon unpause repmgr daemon unpause Instruct all repmgrd instances in the replication cluster to resume failover operations This command can be run on any active node in the replication cluster to instruct all running repmgrd instances to "unpause" (following a previous execution of ) and resume normal failover/monitoring operation. It's important to wait a few seconds after restarting PostgreSQL on any node before running repmgr daemon pause, as the repmgrd instance on the restarted node will take a second or two before it has updated its status. repmgr daemon unpause can be executed on any active node in the replication cluster. A valid repmgr.conf file is required. It will have no effect on nodes which are not already paused. $ repmgr -f /etc/repmgr.conf daemon unpause NOTICE: node 1 (node1) unpaused NOTICE: node 2 (node2) unpaused NOTICE: node 3 (node3) unpaused --dry-run Check if nodes are reachable but don't unpause repmgrd. Following exit codes can be emitted by repmgr daemon unpause: SUCCESS (0) repmgrd could be unpaused on all nodes. ERR_REPMGRD_PAUSE (26) repmgrd could not be unpaused on one or mode nodes. ,