If "failover_validation_command" is set, and the command returns an error,
rerun the election.
There is a pause between reruns to avoid "churn"; the length of this pause
is controlled by the configuration parameter "election_rerun_interval".
This controls the maximum length of time in seconds that repmgrd will
wait for other standbys to disconnect their WAL receivers in a failover
situation.
This setting is only used when "standby_disconnect_on_failover" is set to "true".
If the WAL receiver has been temporarily disabled, we don't want to
wait for it to start up as it may not be able to at that point; we do
however need to reset "wal_retrieve_retry_interval".
"standby_disconnect_on_failover" requires availability of "wal_retrieve_retry_interval",
which is available from PostgreSQL 9.5.
9.4 will fall out of community support this year, so it doesn't seem
productive at this point to do anything more than put the onus on the user
to read the documentation and heed any warning messages in the logs.
This is intended to ensure that all nodes have a constant LSN while
making the failover decision.
This feature is experimental and needs to be explicitly enabled with the
configuration file option "standby_disconnect_on_failover".
Note enabling this option will result in a delay in the failover decision
until the WAL receiver is disconnected on all nodes.
This enable selection of the method repmgrd uses to check whether the upstream
node is available. Possible values are:
- "ping" (default): uses PQping() to check server availability
- "connection": executes a query on the connection to check server
availability (similar to repmgr3.x).
In a situation where only some standbys are cut off from the primary,
a failover would result in a split brain/split cluster situation,
as it's likely one of the cut-off standbys will promote itself, and
other cut-off standbys (but not all standbys) will follow it.
To prevent this happening, interrogate the other sibiling nodes to
check whether they've seen the primary within a reasonably short interval;
if this is the case, do not take any failover action.
This feature is experimental.
Previously, if PostgreSQL was not running on the node, repmgrd and
pause status were shown as "0", implying their status was known.
This brings the csv output in line with the human-readable output,
which displays "n/a" in this case.
