The difference between this and establish_db_connection() is that
it outputs any connection failure as a [NOTICE] rather than an
[ERROR]; it's intended for use in e.g. polling a server to wait
for it to come up/go down, while preventing [ERROR] log lines
which may cause confusion.
There's no compelling reason to require "archive_mode" to be enabled
for streaming replication. It is of course a good idea to archive WAL
using e.g. barman ( http://www.pgbarman.org/ ) as part of a comprehensive
backup strategy, but repmgr and streaming replication work fine without
it.
Per GitHub #141.
Also revise the configuration check for "archive_command" to be
triggered only when "archive_mode" is not "off", as from PostgreSQL
9.5 onwards "archive_mode" can also be "on" or "always".
Updated makefile for deb creation
There's still a bug in the Version field of the Control file (it shouldn't have a 'v' in front of the version).
Will fix that immediately after.
A fix for this was introduced with commit ee9270fe8d
and removed in 4f1c67a1bf.
Refactor the original fix to simply omit attempting to write an invalid entry
to the monitoring table.
Calculate the width of the "Name" and "Upstream" columns dynamically.
Based on pull request #135 by sengaya, edited and modified by myself
to include a psql-like separator line.
removing it.
Basically, on startup the standby will start receiving again from the
begining of the WAL and so received will be lower then applied.
A proper code is needed to make sure the standby is still following the
correct master (as per node information)
used in the cluster.
Main issue was that if the local repmgrd was not able to connect locally,
it would set the local node as failed (active = false). This is fine, because
we actually don't know if the node is active (actually, it's not active ATM)
so it's best to keep it out of the cluster.
The problem is that if the postgres service comes back up, and is able to
recover by it self, then we should ack that fact and set it as active.
There was another issue related with repmgrd being terminated if the postgres
service was downs. This is not the correct thing to do: we should keep
trying to connect to the local standby.
used in the cluster.
Main issue was that if the local repmgrd was not able to connect locally,
it would set the local node as failed (active = false). This is fine, because
we actually don't know if the node is active (actually, it's not active ATM)
so it's best to keep it out of the cluster.
The problem is that if the postgres service comes back up, and is able to
recover by it self, then we should ack that fact and set it as active.
There was another issue related with repmgrd being terminated if the postgres
service was downs. This is not the correct thing to do: we should keep
trying to connect to the local standby.
Ian Barwick