In some corner cases (e.g. immediately after a switchover) where
the current primary has not yet been determined, the provided connection
might not be writeable. This prevents error messages such as
"cannot execute INSERT in a read-only transaction" generating unnecessary
noise in the logs.
1. The target additional-maintainer-clean was misspelled as
maintainer-additional-clean.
2. Add add missing clean targets, in particular sysutils.o, config.h,
repmgr_version.h, and Makefile.global. While at it, use a wildcard
for obj files.
3. Don't delete configure.
4. Remove generated file doc/version.sgml from the repo.
5. Have maintainer-clean recurse to the doc directory.
If "failover_validation_command" is set, and the command returns an error,
rerun the election.
There is a pause between reruns to avoid "churn"; the length of this pause
is controlled by the configuration parameter "election_rerun_interval".
This controls the maximum length of time in seconds that repmgrd will
wait for other standbys to disconnect their WAL receivers in a failover
situation.
This setting is only used when "standby_disconnect_on_failover" is set to "true".
If the WAL receiver has been temporarily disabled, we don't want to
wait for it to start up as it may not be able to at that point; we do
however need to reset "wal_retrieve_retry_interval".
"standby_disconnect_on_failover" requires availability of "wal_retrieve_retry_interval",
which is available from PostgreSQL 9.5.
9.4 will fall out of community support this year, so it doesn't seem
productive at this point to do anything more than put the onus on the user
to read the documentation and heed any warning messages in the logs.
This is intended to ensure that all nodes have a constant LSN while
making the failover decision.
This feature is experimental and needs to be explicitly enabled with the
configuration file option "standby_disconnect_on_failover".
Note enabling this option will result in a delay in the failover decision
until the WAL receiver is disconnected on all nodes.
